Product Manual Extract: Torque Converter Pressure Checks

Table of Contents

1. Engine
2. Electrical System
3. Steering
4. Transmission
5. Brakes
6. Hydraulic System
7. Chassis/Attachment

Overview

This manual provides detailed instructions for performing pressure checks on the torque converter. The procedures outlined below are essential for maintaining optimal performance and ensuring the longevity of your equipment.

Checking Torque Converter Inlet Pressure

Tools Required: CAS-1804 Pressure Test Kit

1. Engage the parking brake to secure the equipment.
2. Start the engine and allow it to reach operating temperature.
3. Using a 20 bar pressure gauge, connect it to test point M5.
4. Ensure all transmission controls are in the neutral position.
5. Run the engine at 2350 rpm.
6. Read the pressure gauge and record the pressure.
7. Refer to page 3 of the manual for detailed specifications.

Checking Pressure at Torque Converter Outlet

Tools Required: CAS-1804 Pressure Test Kit

1. Engage the parking brake to secure the equipment.
2. Start the engine and allow it to reach operating temperature.
3. Using a 20 bar pressure gauge, connect it to test point M7.
4. Ensure all transmission controls are in the neutral position.
5. Run the engine at 2200 rpm.
6. Read the pressure gauge and record the pressure.
7. Refer to page 3 of the manual for detailed specifications.

Usage Recommendations

• Regularly perform these checks as part of your routine maintenance schedule.
• Ensure accurate equipment setup to prevent measurement errors.
• Consult the specifications on page 3 to verify acceptable pressure ranges.