Case 1021F, 1121F Wheel Loader Service Manual
$37.00
New Holland Service Manuals for Case 1021F and 1121F Wheel Loaders
Explore our detailed Service Manuals for New Holland’s Case 1021F and 1121F Wheel Loaders, designed to keep your machinery running smoothly. These comprehensive manuals consist of 1659 and 2119 pages, respectively.
Comprehensive Equipment Service Manual
Product Overview
This service manual provides detailed guidance for troubleshooting and maintaining various components of your equipment, including the engine, transmission, four-wheel drive, and more. Designed for professionals and equipment owners alike, this manual ensures that you have the necessary information to keep your machinery running efficiently and effectively.
Table of Contents
- Introduction
- Engine
- Transmission
- Four Wheel Drive
- Front Axle
- Rear Axle
- Brakes and Controls
- Hydraulic System
- Steering
- Wheels
- Cab Climate Control
- Electrical System
- Platform, Cab, Bodywork, and Decals
- Special Tools Index
- Electrical Schematics 1021F and 1121F
- Hydraulic Schematics 1021F and 1121F
Manual Extract: Parking Brake Control
Button Switch Testing and Troubleshooting
| Test Point | Expected Result | Other Result (Possible Cause) |
|---|---|---|
|
Condition Turn the key switch ON. Measure the voltage from Parking Brake Switch pin 2 to chassis ground. |
Result The voltage should be approximately 24 V. |
Action If the voltage is less than 10 V, check the battery supply and fuse ECA-F6. Repair as required. |
|
Condition Actuate the Parking Brake Switch. Measure the voltage from Parking Brake Switch pin 3 to chassis ground. |
Result The voltage should be approximately 24 V. |
Action If the voltage is less than 10 V, replace the Parking Brake Switch temporarily and retest. |
|
Condition Actuate the Parking Brake Switch. Measure the voltage from AIC connector pin 6 to chassis ground. |
Result The voltage should be approximately 24 V. Consider replacing the Instrument Cluster and retesting. |
Action If the voltage is less than 10 V, inspect the signal wire from the switch to the AIC display. Repair as needed. |
Identify the Tier Level of Your Equipment
Understand the emissions standards applicable to your equipment by identifying its Tier Level. Read more about Tier Levels.
Only logged in customers who have purchased this product may leave a review.
Related products
Reviews
There are no reviews yet.