Kobelco 140SRLC-3 Tier 4 Excavator Service Manual

Product Overview

This comprehensive service manual for the Kobelco 140SRLC-3 Tier 4 Excavator is an essential resource for repair specialists. Encapsulating 1101 pages in a convenient PDF format, this manual is meticulously crafted in English for easy accessibility and understanding. It is identified by the Book Code S5YY0024E02.

Key Features

• Extensive content covering all aspects of the Kobelco 140SRLC-3 Tier 4 Excavator.
• Organized table of contents, including sections on Safety, General Information, Maintenance, Systems, Disassembling and Assembly, Troubleshooting, Engine, and Procedures for Installing options.
• Detailed instructions and diagrams to guide you through repair and maintenance tasks.

Benefits

• Helps ensure safe and effective operation through detailed safety information and procedures.
• Empowers mechanics with detailed instructions, reducing downtime and enhancing repair efficiency.
• Serves as a reliable reference even for experienced technicians familiar with excavator technology.

Usage Recommendations

• Familiarize yourself with all warning plates and decals before beginning any operation, maintenance, or repairs.
• Always refer to this manual for guidance when performing service work, especially if you’re unfamiliar with the machine’s systems.
• Use proper lifting procedures and caution when removing components, especially immediately after the machine has been stopped due to fluid pressure and heat.

Additional Instructions

This manual is intended for the use of experienced mechanics and repair specialists. Thoroughly review the Shop Manual of the Excavator before starting any repair work. Utilize standard protocols to avoid injuries or accidental damage, specifically when dealing with high-pressure components.

Replacing Motor Actuator

• Disconnect the connector attached to the motor actuator.
• Detach FACE and VENT rods connected to the MA mode lever and mode cam from the holder.
• Remove three screws and take out the motor actuator with the MA mode lever.
• Transfer the removed MA mode lever to the new motor actuator by reversing the removal steps.

Replacing Air Mixing Actuator

• Disconnect the connector attached to the air mixing motor actuator.
• Remove the rod connecting the motor actuator to the MA air MIX lever.
• Unscrew three screws and remove the motor actuator with the MA air MIX lever.
• Install the MA air MIX lever on the new motor actuator following the reverse procedure.

Identify the Tier Level of your Equipment (Read our article on
Tier Level)

n