Case SR270, SV300, SV340, TR340, TV380 SkidSteer Service Manual (Tier 4B)

Table of Contents

1. Contents
2. Introduction
3. Engine
4. Power Coupling
5. Front Axle System
6. Rear Axle System
7. Hydrostatic Drive
8. Brakes and Controls
9. Hydraulic Systems
10. Frames and Ballasting
11. Wheels
12. Track and track suspension
13. Cab Climate Control
14. Electrical System
15. Front Loader and Bucket
16. Platform, Cab, Bodywork and Decals
17. Specials Tool Index
18. Electronic Schematics
19. Hydraulic Schematics

Manual Extract: Loader bucket control cylinder – Disassemble

1. Clean the outside of the cylinder. If the hoses were removed from the cylinder, remove the hoses.
2. Fasten the tube (1) in a vise, or other holding equipment can be used. Be careful not to damage the tube.
3. Loosen the gland (5) in the tube with a gland wrench.
4. To prevent damage to the tube, pull the piston rod (3) straight out of the tube.
5. Fasten the piston rod end in a vise. To prevent damage to the piston rod, place a padded support below the piston rod near the piston.
6. Loosen and remove the bolt (14) and the washer (16) that connects the piston on the piston rod.
7. Remove the piston (6) from the piston rod.
8. Remove and discard the seal (11), wear ring (13) and backup ring (12) from the piston.
9. Remove and discard the O-ring (9), backup ring (10), seals (8), and wiper (7) from the gland (5).