White 8510, 8610, 8710, 8810 Tractor Manual

Product Overview

The AGCO White Tractor Manual is an essential resource for owners and operators of the White 8510, 8610, 8710, and 8810 models. This comprehensive service manual, available in PDF format, provides detailed instructions across 705 pages. Written in English, it covers critical maintenance and repair procedures to ensure optimal performance and longevity of your equipment.

Book Number: 79018647

Key Features

• Includes detailed procedures and step-by-step guidelines for servicing and maintaining White 8510, 8610, 8710, and 8810 tractors.
• Extensive coverage of critical mechanical areas such as engine, transmission, and hydraulics.
• Easy-to-follow instructions with diagrams and illustrations to aid in troubleshooting and repairs.
• Structured format with a comprehensive table of contents for quick navigation.

Benefits

• Enhances understanding of complex tractor systems and components.
• Improves efficiency in performing routine maintenance and repairs, saving time and reducing downtime.
• Provides valuable insights and technical knowledge for both novice and experienced technicians.

Manual Table of Contents

• Title
• Introduction
• Splitting
• Engine
• Clutch
• Gearbox
• Rear Axle
• PTO
• Front Axle
• Hydraulics
• Electrical Equipment
• Electronic Transmission Control
• Cab

Usage Recommendations

• Refer to specific sections in the table of contents to address particular issues or maintenance tasks.
• Use alongside regular maintenance schedules to ensure all tractor components are functioning accurately.
• Ideal for use in agricultural settings and workshops where multiple units of the White series are serviced.

White 8510, 8610, 8710, 8810 Manual Extract

Installation of the Trumpet Housing Assembly
Removal: Block the front wheels and remove the rear wheels from the tractor. Secure the center housing with a stand.
Detach the rear cab support attachments involved, above the final drive.
Lift the cab slightly to ensure no interference occurs with components near the cab and windshield.
Provide support for the cab using an appropriate stand.
Finally, remove the circlip (1) and the lower pin (2) of the lifting cylinder, then separate the cylinder from the anchor.